K-array KMT12
Thunder-KMT12 is much more than a standard 12" powered subwoofer. The amplifier mounted onboard is Class D, delivering 2x1000 W at 8 Ohm. The unique four-corner port configuration gives symmetrical back loading to the speaker for extended bass response with very low distortion.
This also gives incredible structural strength to the cabinet despite its light weight. The rear panel provides input for a balanced line signal, a balanced microphone signal with phantom power and digital signals in AES/EBU protocol and also on an XLR for ease of cabling.
Features
- Direct radiating, long excursion 12" driver
- Fitted with integral handles
- Analog and digital AES-EBU input
- Integrated DSP
- Configurable fullrange powered output
- RS485 and USB connectivity for remote control
Specs
Acoustics
- Power handling: 700 Watts
- Max power: 1200 Watts
- Impedance: 8 Ω
- Frequency range: 45 Hz - 150 Hz
- SPL 1W/1mt: 96 dB
- Maximum SPL: 125 dB (cont.) - 131 dB (peak)
Coverage
- Horizontal: Omni
- Vertical: Omni
Crossover
- Type: Internal DSP controlled
- Frequency: Low pass/150 Hz (maximum - preset dependent)
Transducers
- Type: 1x12" (Neodymium magnet woofer with 3" voice coil)
Audio In/Out
- Analog connectors: 2 male + 2 female 3-pin balanced XLR
- Digital connectors: 1 male + 1 female 3-pin balanced XLR
Remote control input connectors
- 1 male + 1 female XLR parallel
- 1 USB B Jack serial converter
Amplifier
- Type: 1 module class D - DSP controlled
- Subwoofer Power Output: 1000 Watts/8 Ω 1% THD + NOISE
- Speakon Power Output: 1000 Watts/8 Ω 1% THD + NOISE
- Frequency response: 20 Hz - 20 kHz
Protections
- Over Temp. (Power Limiting - Thermal Shutdown)
- Short Circuit/Overload Output Protection
- Power Limiting
- Clip Limiter/Permanent Signal Limiter
- High Frequency Protection
Other
- Nominal power requirements: 100-240 V at 50-60 Hz
- Certification: IP 20 (53 with K-AMPCOVER accessory)
- Dimensions: 32,6x32,6x43,2 cm
- Weight: 15,6 kg