Active Subwoofer Park Audio NX183-P

Park Audio NX183-P

It is based on the NX183 subwoofer and differs from it by the presence of a built-in amplifier. The built-in class D amplifier with a DSP platform is installed in an isolated compartment at the rear of the case. The amplifier has protection against overload, short circuit and overheating. Cooling of the amplifier is forced with smoothly variable intensity. The amplifier's power supply is a switching power supply with power factor correction (PFC), which allows the subwoofer to operate over a wide range of supply voltages without reducing the amplifier's output power.

Setting and control

• LСD display for information output and system setup
• System menu for change sound setting: levels, EQ, separate components delay and general system delay
• Intuitive navigation through the system menu by means of encoder
• Built-in noise generator for live sound setting
• USB port for system setting by personal computer
• Original program ParkControl for system and parameters setting by personal computer
• Ability to save 10 user presets

Features

• Maximum SPL 133 dB
• Frequency range 38 – 100 Hz
• 18”, 1200W woofer (B&C SPEAKERS) with 4″ voice coil
• Acoustic design – rectangular cabinet, bass reflex
• Cabinet material – birch plywood 18 mm
• Black water-polymer finish
• Protective steel grid with powder coating
• Acoustically transparent polyurethane foam, glued to the inner surface of the grid
• Built-in D class amplifier (2000 W RMS), switching power supply with PFC
• DSP engine, acting as crossovers, EQ, time alignment, limiting and speakers overload protection
• Two line inputs and outputs – 2 х XLR
• Line output switch: THRU/SAT (THRU – parallel connection to input, SAT – send processed signal to line output)